Pinch Tube Dispensing Pen DV-5110

Art.-Nr. 504856
Product-ID DV-5110

manual, up to 3,5 bar, previous number: 700PTPCW

96,94 € / bucată
Cantitate Preț / bucată
bis 3 96,94 €
ab 4 94,01 €
ab 10 92,13 €

* Preț European. Nu este inclus TVA și Livrarea

Pregătit pentru livrare,
Timp de livrare 1-3 zile lucrătoare

The "pinch tube" pen model DV-5110 is ideally suited for the manual application of adhesives, lubricants, solvents, cyanoacrylates, anaerobics and other low viscosity materials. Applications may include the dispensing of lines, manual dispensing of shots or filling small cavities, to name only a few applications. The "pinch tube" is the only part that comes in contact with the material. When needed, the simple part design allows very easy exchange of the "pinch tube" assembly. The "pinch tube" assembly is available in  two ID's: 1.8 mm (0.070") and 2.5 mm (0.10"). The pinch tube is made of polyethylene PE.

Mode of operation
While idle, the valve is closed. Utilizing an internal spring mechanism, a piston with "blunt edge" design, provides closure to the "pinch tube" assembly, not allowing the material to flow out. By depressing or squeezing the hand lever, the piston removes pressure from the  "pinch tube" and the valve is opened. The stroke of the hand lever can be adjusted via a small set screw. This fine adjustment provides control over the opening of the "pinch tube" gap. The simple tool design allows very easy replacement of the internal "pinch tube" assembly. To dispense UV materials, black pinch tubes and flow tubes are available to protect the material from light to prevent drying.

Dispensing materials
Adhesives, UV adhesives, Acids, Alcohol/Methanol, Anaerobics, Bases, Cyanoacrylate, Oils/Greases/Lubricants, Silicone (RTV)/Gels, Solder Masks/Pastes/PVA, Solvent

  • Versandgewicht 0.14 kg
  • Funcționare manually
  • Materialeinlass Luer-Lock (female)
  • Antrieb manually
  • Medienberührend tube only
  • Sprühen --
  • Mikro-Dosierung --
  • Gefüllte Materialien +
  • Material PE
  • Gewicht 40 g
  • Länge 104 mm
  • Materialauslass Luer-Lock (male)
  • Materialviskosität (max.) 50.000 mPas
  • Durchflussmenge 1680 ml/min (water, 3.5 bar)
  • Dosiermenge (min.) 0,0075 ml
  • Materialdruck (max.) 3,5 bar

Desene tehnice

  • Klebstoffe +
  • Säuren +
  • Alkohol / Methanol +
  • Anaerobe Klebstoffe +
  • Basen +
  • Conformal Coatings -
  • Cyanacrylate +
  • Öle / Fette / Schmierstoffe +
  • Silikone 1K (RTV) -
  • Lotpaste -
  • Dichtungen +
  • Lösungsmittel +
  • UV-Klebstoffe +
  • FDA-Konform +
Zuletzt angesehen